Mechanical ventilation · AARC 2024

Patient–Ventilator Assessment

Use the AARC guideline to understand what to assess at the ventilator, from tidal volume and plateau pressure to airway security and humidification.

Independent PulmTools educational summary

Who this guideline covers

Patients receiving mechanical ventilation, including invasive and noninvasive support where specified

Read the original guideline

Key recommendations

AARC used GRADE. The literature review included all age groups. Apply each recommendation to the patient and interface it addresses, using population-specific targets where relevant.

  • Check plateau pressure and tidal volume

    AARC recommends checking plateau pressure and assessing and documenting tidal volume by predicted body weight as part of lung-protective ventilation.

    Strong · high certainty

  • Assess PEEP and auto-PEEP

    Record the set PEEP and assess for intrinsic PEEP where a valid measurement is feasible. Incomplete exhalation can raise total PEEP above the set value.

    Strong · high certainty

  • Use driving pressure as additional context

    AARC suggests assessing driving pressure. Interpret the difference between plateau pressure and total PEEP in the context of valid measurements, patient effort, and the clinical course.

    Conditional · low certainty

  • Assess oxygen delivery and humidification

    Review FiO₂ in relation to oxygenation. Assess humidification adequacy during invasive or noninvasive ventilation. AARC also suggests checking whether the humidification device used for NIV is appropriate.

    Conditional · very low certainty for FiO₂ and humidification adequacy · low certainty for NIV device choice

  • Inspect the interface, airway, and cuff

    Inspect skin around artificial airways and NIV interfaces and use a manometer when assessing cuff pressure. AARC also suggests evaluating dressings and checking artificial-airway placement and securement.

    Skin and manometer assessment strong / high · dressings and securement conditional / low

  • Account for the limits of remote assessment

    AARC suggests direct bedside assessment when resources permit. In resource-limited settings, telemonitoring can supplement the assessment.

    Conditional · low certainty

Evidence ratings refer to the original AARC guideline.

Clinical context

An assessment recommendation tells you what to measure

An individual ventilator target depends on the patient and the condition being treated. The ATS ARDS guideline provides disease-specific tidal volume and plateau-pressure targets for adults with ARDS.

The measurement conditions matter

Check whether a plateau reading reflects a valid inspiratory hold and whether total PEEP was measured under appropriate conditions. Patient effort or a leak can make a displayed value hard to interpret. The static compliance calculator explains both measurements and how they enter the calculation.

Practice case

A passive, ventilated adult has a plateau pressure of 26 cm H₂O, set PEEP of 5 cm H₂O, and measured total PEEP of 10 cm H₂O.

What is the calculated driving pressure?

Show the reasoning

The calculated driving pressure is 16 cm H₂O (26 minus 10), assuming the holds were valid. Using the set PEEP would give 21 cm H₂O and would miss the contribution of intrinsic PEEP.

References

  1. AARC Clinical Practice Guideline: Patient-Ventilator Assessment

    Goodfellow LT, Miller AG, Varekojis SM, LaVita CJ, Glogowski JT, Hess DR. Respir Care. 2024;69(8):1042–1054. doi:10.4187/respcare.12007.

    Primary source for the assessment recommendations, GRADE ratings, and four clinical questions.

  2. ATS guideline update on management of adult ARDS

    Qadir N, Sahetya S, Munshi L, et al. Am J Respir Crit Care Med. 2024;209(1):24–36. doi:10.1164/rccm.202311-2011ST.

    Disease-specific context for lung-protective ventilation targets in adults with ARDS.

For education. Use patient-specific assessment, the full guideline, and local protocols for bedside decisions.